Crafty Waterpipe Adapter (CU-Mod v2)
Please check out the new and improved V3 Adapter!
Designed to fit both 14mm and 18mm female bubblers / waterpipes, this version 2.0 adapter replaces the top half of the Crafty vaporizer's cooling unit. (This adapter is NOT compatible with the Mighty Vaporizer)
- Unlock and remove top-half of cooling unit
- Align CU-Mod with Cooling Unit's internals and press-fit onto bottom half of cooling unit
Part is made from Aquarium-Grade Silicone and Corn Starch. It is non-toxic and vapor safe when cured. Adapters are safe to clean with any traditional glass cleaning methods including hot water, Isopropyl Alcohol, and PBW.
(These parts are cast and trimmed by hand, the adapter may have slight imperfections such as bubbles. All parts are examined for critical issues and re-cast if necessary. Any remaining defects will be purely cosmetic and will not affect performance. Please contact us ASAP if you discover a critical defect!)
*While we make every effort to pre-make these adapters, your adapter may not be fully cured when delivered. Freshly cast parts will have a vinegar smell while they cure. If the vinegar smell remains after several hours, soak in a cup of water for 24-48 hours to accelerate the curing process*
*This listing is for the silicone adapter only - GLASS WATER TOOL NOT INCLUDED!*
Posted by Unknown on Jun 5th 2017
Unfortunately my Crafty died on me a few days after receiving my adapter (not related) so I didn't get to test it as much as I would have liked. It seemed to work fine although mine didn't seal up as tight as I thought it would. That could have also been because it needed to cure more . So I can't fault it very much without getting to test it like I wanted. I personally think the Crafty just isn't designed very well for using with a water attachment. The customer service on the other hand was outstanding. It took a little while for it to ship but Mike sent me a nice email about the delay and for that he gets 5 stars from me. Excellent work Mike, keep up the hard work.
Best adapter for the Crafty so far.
Posted by Unknown on Mar 23rd 2017
The adapter is a little more on the silicone/rubber side, it's not plastic just to warn other buyers. If your water pipe's downstem is on an angle you will have to hold the crafty or the adapter will fall off, if your downstem is verticle, the adapter can support the Crafty. All that being said it works flawlessly. My particular adapter does not fit as perfectly as the one is the photo, but that is to be expected with 3D printed material and still seals properly, it just doesn't have as clean lines and you can see the rubber o-ring from the cooling unit on one side. In terms of performance, it works extremely well. I got the best water pipe session with my Crafty with this adapter and there was no influence on flavor. Great buy and highly recommended.
60-Day Satisfaction Guarantee