Delta65 FPV Canopy

This thermoformed canopy was built to hold an All-in-one FPV Micro Camera on your 65mm class quadcopter with an Inductrix sized Flight-Controller.  Weighing in at under 1.10 grams, this canopy was designed to not only hold your FPV at the perfect angle for aggressive indoor aerobatic maneuvers, but also has an additional hump behind the antenna to further protect the FPV dipole antenna and camera in the event of an inverted crash landing. 

Formed from a solid sheet of PETG plastic, these canopies are substantially more durable than traditional 3D-printed camera mounts, and protect the entire Flight-Controller with minimal change to overall weight of your quadcopter.  Canopies are currently available in Smokey Black, Translucent Blue, and Clear colors.

NOTE: Canopies are sold UN-TRIMMED! You will be required to cut off excess raw plastic as needed. We suggest a sharp razor blade to gently trim the profile and break away excess material.  A handheld rotary tool (such as a Dremel) with a sanding barrel bit can be used at LOW speeds to clean up excess material on the canopy, although be careful not to overheat the plastic as it will warp when overheated!  We suggest a small dab of hot-glue applied to the camera once installed and angled properly to ensure camera doesn't pop out or change angle after a hard crash. 

CAMERA AND DRONE NOT INCLUDED WITH PURCHASE - this purchase is for ONE empty drone canopy cover.